Ideling problem after slave cylinder swap

A forum for the legendary Nissan Pathfinder and Infiniti QX4.
Post Reply
User avatar
Fisherdude
Posts: 240
Joined: Sun Dec 28, 2008 7:15 pm
Car: 1996 Nissan Pathfinder 4x4 SE
Contact:
Contact Fisherdude

Post

When I changed my slave cylinder and hose on my manual 3.3, It started to idle really low and stall out when I started it cold. I adjusted my idle screw so it idles at 600rpm now again as opposed to the 400rpm it went to. How does the slave cylinder and engine idle compare?

Top
User avatar
Chuck Tribolet
Posts: 1490
Joined: Mon Nov 24, 2008 3:15 pm
Car: '01 Nissan Pathfinder
'87 Chevy Corvette
'01 Toyota Camry daily driver
'98 Boston Whaler Montauk
Location: Morgan Hill, CA and Marina, CA
Contact:
Contact Chuck Tribolet

Post

Clutch dragging a little with the new slave cylinder?

You bothered something like an O2 sensor?

Chuck
Top
User avatar
Fisherdude
Posts: 240
Joined: Sun Dec 28, 2008 7:15 pm
Car: 1996 Nissan Pathfinder 4x4 SE
Contact:
Contact Fisherdude

Post

clutch seems normal, and it's new. I didn't see any O2 sensors around there.
Top
Post Reply

Return to “Nissan Pathfinder Forum / Infiniti QX4 Forum”

Search for Nissan stuff on ebay!
Find Your Forum!

 

NICOclub's Nissan forums and Infiniti forums and all affiliated sites are the property of HDS Holdings, Inc.
They are independent publications and are not affiliated with or endorsed by Nissan or Infiniti.

Information Copyright © 2000-2026 by NICOclub, all rights reserved. Material may not be copied or reprinted without written permission.

Privacy Policy