I need some help, Philadelphia PA

[OutToWinPAHC]

I am trying to get my T56 in and its just too tight on my 240sx. I removed a TH350 and I am swapping it to manual trans. Anyhow I am posting on the forums for a little help. I only have 2 options, cut the floor open which requires removing a rollcage, dash, seats and carpet, or lowering the engine / crossmember down and inch or 2 and mating them and then jacking them in place.

I am trying to find an engine lift, but no luck yet. So if your interested in helping me work on my Spec sponsored LS/T56 Nissan 240sx and have an engine crane and maybe a tall floor jack please let me know.

Yuingling is on tap, and Chickies and petes is up the block, dinner on me

[Initial_R90]

you still having problems with this ?

[Initial_R90]

I remember on my car with hilson mounts i could not take the transmission out without moving the motor

[OutToWinPAHC]

Nah its in and I made a crossmember for it.