I need help with my clutch

[xiDEADWALKERix]

So i just finished installing my new clutch and filled up the transmission with fluid. Then i go to start the car and let it run for a few minutes. I press the clutch and go to shifty into reverse and it feels like its not disengaging like it should. It wont shift into any other gears what could the problem be?

[eastcoastchaos]

does the pedal feel like normal? If not there could be air in the line. Did you get the little forked piece and the TO bearing put on correctly. and is the slave cylinder put back on correctly?

[xiDEADWALKERix]

everything went back in the way it should but i just felt it again and the pedal feels like its not coming as far back as it should

[eastcoastchaos]

there really shouldn't be any air in the lines if you didn't open a bleeder or anything, but it can't hurt to bleed it anyhow. you might need to remove the little damper box to bleed it properly.

[xiDEADWALKERix]

Well i fixed my clutch issue and it drove fine for a little bit. Now the car wont start. First it would idle at like 700 rpm and slowly go down now the engine wont turnover. Everytime i fix something something else breaks.