i give you a pic of a hot girl, and you help me out, right??

[gbaz77]

ok, heres what i read today.

by Kansei240sx "old Z lightweight flywheels fit as well, IE L28 for RB20/25"

Offline

973 posts1991 Nissan 240sx HatchbackTulsa Ok11-1-2004Add this post to My Notepad « Re: (xdream) 1:19 AM 12/14/2006

can anyone confirm this?? i have a link for an rb20det flywheel and the L28 flywheel....

any confirmation would be apprectiated.

rb20 flywheel - http://cgi.ebay.com/ebaymotors...ZWDVW

L28 flywheel- http://cgi.ebay.com/ebaymotors...ZWD1V

and the hot girl.

[240z4u]

I can niether confirm nor deny. Although I do know an L motor has six bolts as well (i used to have one). I also know the RB/L motor clutches interchange.

You are comparing a factory resurfaced flywheel to a lightened unit. The L flywheel is a stocker.

I am pulling an rb20 flywheel from my car tonight. Email me directly if you need it.

Evan

[Sky80]

Fit what? ok so we have two flywheels but you didnt say what your putting them in? ka? RB20/25/26? vq?vg?

[gbaz77]

RB20

[Kansei240sx]

It will fit on there, but the hole for the dowel on the back of the motor where the flywheel is bolted to, need to be drilled out by yourself or a machinist on the L28 flywheel.

[Stealth-Z]

Kansei240sx is right about the dowel pin on the RB flywheel.There is a slight height difference between the L and RB flywheel. Most likely would not effect much.If you were to try the L flywheel, get one for the 2+2. There is more clutch area. Most likely there is not a lightened version of it though.