How to install headrest monitors

[anthony870]

So I just got my headrest monitors in and tried to put them in the car.



The wire for the monitors is in the pole so it has to run through the seat. What I am wondering is how do I get to it when its inside the seat. is there a hole in the bottom of the seat somewhere. I don't see anything. Once I find out how to get to it while its in the seat I can figure everything else out. Thanks in advance.

[anthony870]

So after messing with the seats for a while I finally found a spot to get the wire out. Now it is too dark out so will wire them up tomorrow hopefully.

[Tacuvito]

Any progress with this project?

[anthony870]

yea. sorry been busy and hadn't posted it yet.

the headrest monitors are in and working. once i got the wire out of the seat the rest was cake.

[TexasMade89]

yea. sorry been busy and hadn't posted it yet.

the headrest monitors are in and working. once i got the wire out of the seat the rest was cake.

so did u install the monitors into the headrests? or did u buy the headrests with the monitors already in them...and how did u eventually route the wires from the seat to the stereo?

[anthony870]

These came in as the whole headrest. There is a spot at the bottom on each side of the front seats that you can reach in and grab the wire from. Then I jut ran all the wires under the seats and plugged them in. Used the fuse box for power and a bolt on each seat for ground. It was a real easy install. The video cable I just routed out the passenger side and sent under the seat.