HillKill CA bit the dust

[DrIft Ready]

Well a New CA18det is born and wll be running at the end of this weekthe old motor sounding like it had a blown lifter..it blew a lifter a few months back and just put a new one in and fixed that..Anyway..we where planning on just pulling the motor out and putting new bearing and rings and get the head done.After 30 events the motor need a little freshing up.so we conpresstion tested it and..1-130. 2-120.3-100. 4-110...not looking good..so we pulled the head off and this is what we foundso I call Neo Tech up and asked him what he has..the one we came home with has 67km on it with a s14 t28 turbo and a OS Gikin twin plateSweet here is a sneak peak of what the new on is going to look like in a week

[bentvalves]

so did NEOTECH provide the first engine, and is the second one a "FREE" replacement, or did you just purchase a new one?

[nvrplzd240]

Careful with that clutch bro. It's a little touchy to drive around town and it holds like no other. It's been the cause of right around 4 transmission's breaking on a friend of mine.

But besides that.. looks like a pretty clean engine.. good luck with her!

[r34 gtr]

i dont think anything is being replaced for free after 30 events unless its a sponsor.

got some wicked detonation there didnt ya? totally fixable, but will require a good bit of work. now is the time for a 4 port head and some forged slugs for that old engine.

oh, and dont forget to throw in a little more fuel or less timing so you dont do that again...

[float_6969]

Good ole' Number 3. I think that cylinder runs lean...