DALAZ_68 wrote:do you have any for a CA18?
Yes sir, shoot an e-mail to
[email protected] and mention the thread on NICO I want to say we've had folks use the SR one with no issues, but I can't quite remember at the moment, so I'll need to double check.
240_fun wrote:Yo, I bought a line before and it fit perfect and never had an issue or anything. Now I have a new car and need another line since mine is leaking
O and BTW do you know if you could make a line that would go from a SOHC KA to a DATSUN 720 Rack?
Sure thing, you can order them right on our website now
http://www.fujiispl.com
As for the second question, we should be able to make that up fine, if there was any way you could send us the oem stock line for a 720 so we could get the fitting size off of it for the rack that would make it doable, unless you know fittings pretty well and know what size it is. We would also need a length from you as well. Shoot me an e-mail though so we don't have to clutter up the thread figuring it out if you don't mind. My e-mail is
[email protected]
Paul Wall wrote:Do you have anything for a 1993 Infiniti Q45?
Are these any better than OEM?
I don't need any but if they are better than OEM I might consider going with these.
They are better then OEM, the pressure rating and materials used are of a much higher grade. We have not done a line for a Q45 yet so we would need and original line to get measurements and sizes off of. But, we are willing to do that at no extra charge, and can ship your factory line back to you. Like I said above, shoot me an e-mail and we'll discuss it.
[email protected]
Klits562 wrote:just got mine into the mail today looks good
i was wondering if theres any torque specs for the fittings on both ends of the line mine were all loose so im assuming they need to be tightened but is there any specific amount of torque to use?
also should i apply any teflon to the threads of the fittings?
Sorry about the long delay here, I'm assuming you've put the line in by now, but either way, you do not need teflon tape on the fittings, they are tapered fitting that seals once tightened down, if you put teflon on already then it wouldn't be a bad idea to pull it back off, however if it's not leaking then you should be ok. As far as tq settings, a turn with the wrench beyond finger tight and you should be fine.
RoyalFortune wrote:How much for SS lines I have the s13 with SOHC rack and have the HICAS pump on the sr20 shipped to 92117 ?
Again, sorry for the delay, as far as ordering a line, just hop on
www.fujiispl.com and order a stainless line for an SR20, since where the line bolts to the rack is on the same side for sohc and dohc KA.