HEPL! redtop wont rev past 2K please help!!

[chickenknob]

reving smoothly it wont go past 2 i changed the maf from a on redtop one to a new SOHCand its still doing it wiring looks good to me!runs great till 2Kthanks for any help!!
Modified by chickenknob at 12:11 PM 11/17/2006

[FSUDrifter]

test the voltage on the maf, also you can get a pinout for the ecu and run wires straight from the ecu to the sensor.

also check tps

[chickenknob]

the wat should the voltage to the maf be?and w swapped the tps and its still doing it:(

[Blown240sx]

idle voltage should be .5v or around that.

[chickenknob]

1st pin 12v2nd pin 0v3rd pin 0v

tested if any of them ground and they do notshould there be a ground in the 3 wire going to the maf?

[chickenknob]

i unplugged the TPS revs like a champ!?!

[Deadrodent]

bump for the same problem...