Help, put engine, cams and ecu, won't start

Post by **Luderacer14** » Mon Jul 10, 2006 1:59 pm

Like the title says, i installed a used engine, put in crower stage 2 cams. Made sure it was on the second mark on crank and first 2 lobes facing outwards. Put back the same way and put distributer on linning with the mark and indention. Put in z32 maf, new turbo setup. I have fuel with my ams 72 lbs injectors, and have spark. Only thing it's leading to is timming. But i put the cams in correct and i made sure it was not 180 degrees off, any help would be great, thxs. Oh yea, i left my rear o2 unhooked and my egr temp.
Modified by Luderacer14 at 5:10 PM 7/10/2006

Post by **tigwebu** » Fri Jul 14, 2006 7:43 am

Bump for an answer

Post by **Luderacer14** » Sat Jul 15, 2006 2:57 am

Thxs for the bump, it starts now but runs like crap, bogs and can't idle. Check out my other post guys.

Help, put engine, cams and ecu, won't start

Help, put engine, cams and ecu, won't start

Re: (tigwebu)

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums