Help!! My S13 won't start!!

ONLY for ADVANCED technical discussion about the 240sx!
rousie13
Posts: 4106
Joined: Fri May 09, 2003 5:55 pm
Car: 2006 Nissan 350z Track Edition, 1997 Ford F250 4X4
Location: Delaware, OH

Post

Well my car has been acting up lately. Yesterday it wouldn't start at all but it push started, so I replaced the starter. Today it started up fine like 3-4 times after I replaced the starter. Then I went to step on the gas and it like died out and then reved up. I shut the car off after a couple minutes of running, and it won't start now. The idle has been high when the cars warmed up too. The engine cranks, but just won't fire. I put new plugs and wires in about a week ago too. Any ideas on what to check, so I can get my car fixed ASAP?? Also when the car was fairly warm I squeezed the hose going to the IACV-Air Regulator and the idle didn't die down, so would all my problems be coming from this thing??


rousie13
Posts: 4106
Joined: Fri May 09, 2003 5:55 pm
Car: 2006 Nissan 350z Track Edition, 1997 Ford F250 4X4
Location: Delaware, OH

Post

I just checked the fuel line and we're getting pressure from the fuel pump, so it's not that.

rousie13
Posts: 4106
Joined: Fri May 09, 2003 5:55 pm
Car: 2006 Nissan 350z Track Edition, 1997 Ford F250 4X4
Location: Delaware, OH

Post

I just checked the computer and it was flashing code 13, which is the coolant temperature sensor. Would that make my car do what it's doing?

rousie13
Posts: 4106
Joined: Fri May 09, 2003 5:55 pm
Car: 2006 Nissan 350z Track Edition, 1997 Ford F250 4X4
Location: Delaware, OH

Post

I just check the harness for the temp sensor and the positive is reading 10.2 V and the ground is reading .135 What is going on?? The FSM said the ground should have continuity and the positive should read 5V. Please help!!

User avatar
Axel Grungy
Posts: 4711
Joined: Tue Jul 08, 2003 8:13 am
Car: 2001 G20 5spd
Location: Cincinnati OH

Post

check and make sure the connection isnt all gummed up, my car was having serious probs because of it, stupid as it may seem. just a bad connection for the coolant temp sensor. HTH


Return to “240SX Technical Forum”