heater core hoses in a s14 rb25

[StricNyne]

well since i changed my intake i dont half of the cooling lines and im not to sure where to run the heater core lines, i have one outlet in the front of the motor and its the same size of the heater core hoses, and there is one in the rear of the motor with same size diameter hoses, i wish i had pics but my thumb drive is lost i can take some tonight, basically i need to know which heater core hose goes where

[s14_sport]

im always the last person to get on a person about using 'search' button. But USE the SEARCH Button!!

I had this same question among 50 million other questions when I was doing my 25 swap. I searched, found and conquered.

[StricNyne]

well genius i said i am using an custom intake normally the two heater core hoses would connect in the rear of the motor, im basically wondering where the source nipples are at so i can connect it there bypassing a lot of the other cooling lines
Modified by StricNyne at 8:11 PM 12/28/2007

[BoostFab]

well genius i said i am using an custom intake normally the two heater core hoses would connect in the read of the motor, im basically wondering where the source nipples are at so i can connect it there bypassing a lot of the other cooling lines

if i remember, the rear of the block goes to the top port on the firewall heater core, and the lower port connects to the rear of the intake manifold. i'll look at my engine later and post some more info

[StricNyne]

thnx boost, im gunna have pics that will clarify up a lot also once i get this done i can torque my intake manifold down and be down with whole intake side

[KFL]

[StricNyne]

thnx alex, and DAMN i didnt now u were a member before me !?!?!!?

here is where the water nipples are at and where i think they go

[StricNyne]

TTT

once this is done i can continue working on my car

[BoostFab]

i just looked at the motor, are you still using the stock oil cooler where the oil filter is.... if not, then the lines you circle above is where the lines will go.
Modified by BoostsFed at 4:05 PM 12/30/2007

[StricNyne]

i am not using stock oil cooler, and its just like in my diagram ?