I just bought this off ebay not to long ago, it's a resonator/cat replacement. So my ? is, would the obx or ebay knock off headers bolt up to this? It's 3 inch in and out. Sorry for the phone pics.
<center></center>
Headers/test pipe question.
Re: Headers/test pipe question. (E_Con1990)
what a dumb question... you should be able to figure that answer out yourself if you even have a slight clue about the part you bought... why would you have headers and a 3 inch test pipe on a NA car... you should have bought a properly sized exhaust
-
wa-chiss
- Posts: 2569
- Joined: Mon Feb 20, 2006 10:23 pm
- Car: 1990 Nissan S13 H/C KA24E
2005 Toyota Sequoia
1976 Honda CB750F Super Sport - Location: San Angelo, TX
Re: Headers/test pipe question. (LessRice)
Dude, cut the guy some slack. Don't just jump on his d!ick if he has a question.
O.P.- it should bolt up just right. It is too big for whatever header you get but it will bolt on just fine. I have the OBX (KA24E motor) and the colector was kinda small. I didn't measure it but it looked smaller than 2.5".
O.P.- it should bolt up just right. It is too big for whatever header you get but it will bolt on just fine. I have the OBX (KA24E motor) and the colector was kinda small. I didn't measure it but it looked smaller than 2.5".
Re: Headers/test pipe question. (LessRice)
It will be Ka-t in the future.
Re: Headers/test pipe question. (wa-chiss)
Thanks! That's what i needed to know.wa-chiss wrote:Dude, cut the guy some slack. Don't just jump on his d!ick if he has a question.
O.P.- it should bolt up just right. It is too big for whatever header you get but it will bolt on just fine. I have the OBX (KA24E motor) and the colector was kinda small. I didn't measure it but it looked smaller than 2.5".