Has anyone de-badged a G37 coupe? I'm thinking of doing it.

[Potomac-Greg]

There's a lot of badging on the back (the gigantic infiniti logo, the word "i n f i n i t i" and the "G37" badge). My first thought was to pull them all off. Then I thought maybe just leave the Infiniti badge. But it's HUGE. I fully debadged my last black car (Audi A6 2.7T) and it looked phenomenal.

I assume it's just glued on, and a heat gun + rubbing will get it off.

Thoughts?
Modified by Potomac-Greg at 7:36 AM 8/14/2009

[KingsOfCali]

Heat Gun and either rubbing alcohol or Goo-Gone should do the trick. Buff if nesc.

[Potomac-Greg]

Heat Gun and either rubbing alcohol or Goo-Gone should do the trick. Buff if nesc.

I think I'll start with the "Infiniti" letters and then decide if it needs more (less).

[G_whizz]

Take everything off but the Symbol. I did and it looks great!

[marlin29311]

Use a heat gun and fishing line.

[pfarmer]

Use a heat gun and fishing line.

I would go with dental floss as some fishing line is very abrasive.

Perry

[audtatious]

Personally I am thinking of removing the logo first to see how that looks. Then removing INFINITI later if I think it's necessary. I don't want the back end "bald", just less cluttered.

[Potomac-Greg]

I pulled off the "INFINITI" badges. I like it. I now kinda wish the logo was a little lower.

[audtatious]

I'm surprised at how well the Infiniti letters stay on considering how small they are.

I'm sure you can find a Infiniti logo on ebay that is smaller than the one you have now (to me, it's huge for the area). The one I have sitting around here from a G20 is smaller....

[puckfanla]

I just took my INFINITI lettering off this weekend. Still thinking about removing the G37S badging. I used some goo gone, fishing line and elbow grease after letting the letters soak in the GG for a couple minutes. I think it looks clean like the picture shows.

[AZhitman]

I like the debadged look as well.

Dental floss + Goo-Gone, and make sure you polish and wax GOOD after removal.