Hey guys!

Excitedly ive been able to bring an r32 GTST into the country or atleast will be shortly.

I have a short list of basic mods im working on getting, coilovers, exhaust, intake and such.

Now im trying to figure out how much wider the rear fenders are on the GTR versus the GTST and i was hoping someone here might know or have a GTR they might be able to measure?

Short end of the story, im looking to put GTR front fenders (and corner lights) on the GTST to get that nice "hourglass" look of the GTR. I dont want the front end to look out of proportion with the rear however and hopefully someone here might have some info i havent been able to find.

Hopefully someone can ive me some insight!
-Gen

Let me know what you need, I can measure my car no problem.

Well i need to get a good idea of how wide the fender is. I guess maybe a measurement from where it meets the trunk to the outside of the panel? Is there a way you could take a picture?

Maybe looking down over a ruler from the trunk seam to the outside of the panel?

So there's definitely a decent amount of error in these pics, but hopefully this helps a bit. Second pic i went off of the upper most coilover spring coil (typical japanese/taiwanese setup), so if you have coilovers, it should be fairly close.

That should give me a general idea! Thanks so much man!

No problem! Post in here if you need any other measurements!