going rotary need help

Post by **djaztek12** » Wed Jun 17, 2009 12:02 pm

going rotary need help can any 1 help how dificult is to mount the motor on the 510 crossmember or just to do the whole swap can any 1 help . thanks again

Post by **evildky** » Thu Jun 18, 2009 5:59 pm

cut weld repeat, any radical swap comes with a bit of fab work

Post by **HowlerMonkey** » Tue Jun 23, 2009 6:24 pm

I've turned around the pan on a 1976 cosmo 13-b engine to put it into a RX-2.

The parts are available to do such things but the noise is an entirely different issue.

I recommend a long primary exhaust with two stainless packed pre-silencers and a huge and expensive rear muffler..........or earplugs.

Post by **djaztek12** » Thu Jul 09, 2009 11:52 am

the rotary swap is coming along real good nice and, clean i will take plenty of pictures when its done. the swap was no big deal, it was easier the i though

p.s sorry for the spelling? lol lol

Post by **djaztek12** » Fri Jul 10, 2009 8:02 am

here are some pictures of the project, so you could see im not BS, is still not done. just take that in mine before you criticize me,and work. also im not a mechanic just a guy that likes working on cars, and this is my first 510 project only major part of this project was to cut and flip and re-weld the crossmember, make the front motor mount ,and also the tranny mount. is almost there, just need a couple of more detail.http://s928.photobucket.com/albums/ad121/alexruano/

going rotary need help

going rotary need help

Re: going rotary need help (djaztek12)

for all the critics and the haters

Re: for all the critics and the haters heres a link to some pictures

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums