For those in need of custom fab work...

[Camel]

For those of you in need of custom fab work, my cousin (in-law) in NC does awesome work and can think up a solution for about anything.

His main profession is building stock cars but has recently ventured into some other territories.

He has done some work already for the import community (roll cages, brackets, etc). I believe that he is going to do a custom lexan hatch glass for Exar-Kun for a modest amount in the near future. Window rib supports and all.

If you need his help with a project, give him a call. Let him know that you are a NICO member from this nissan community.

Here is his site:

http://www.rhineenterprise.com

[BuudWeizErr]

I would be interested in the Lexan rear glass.

[Camel]

Here is what he quoted for someone else on the job:

Made from 3/16 Lexan – 130 dollars a sheet

Made from 1/8 Lexan – 100 dollars a sheet

Total of 400 labor including the window braces that you will need for the center of that large window. (He said that he would probably run 2 on the inside of the window, bolted to the frame of the hatch.) All done up with button cap racing bolts.

This was just an estimate, and the job has yet to be done. But i think it should be complete by the end of February.

[solaris22]

What about motor mount fabing for a custom engine install?

[Camel]

Depends on what you want done. I am sure that if he could look at it, he can figure something out. Give him a call, or email. And don't forget to tell him youre from NICO.