fmic piping/acuator signal???

Post by **itssr20** » Mon May 10, 2004 7:26 pm

when doing fmic piping, where is the best place to put the nipple that sends the signal to the actuator?

Post by **SpeedRacer1** » Mon May 10, 2004 7:26 pm

Anywhere is fine. The stock SR ic piping has it on the cold pipe. Some FMIC kits have it on the hot pipe. Some upgraded turbos come with the nipple built into the compressor housing only inches from the compressor wheel. This makes the length of the hose between the nipple and wastegate only a couple inches. You can choose what you would like, closer to the compressor will result in less vacuum hose being used.

Post by **itssr20** » Mon May 10, 2004 7:26 pm

thanks for the reply.I got another question about intercoolers in general, does it matter which side(inlet/outlet) you use, because the way i am mounting mine- i have to flip it upside down. Do intercoolers flow in specific directions? or does it not matter, its a medium NPR by the way

Post by **rudee023** » Mon May 10, 2004 7:26 pm

Shouldn't matter.

fmic piping/acuator signal???

fmic piping/acuator signal???

intercooler flow direction?

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums