Installed this fmic on my 93 coupe with silvia front and cannot get this bumper to fit on with out hacking out the whole bottom section of bumper and obviously dont want to. I have brackets welded to the top of the metal bumper support as you can see..just want some ideas on how to get this to work, the intercool is 27"L/ 11 1/2"wide and 3" Thick. Need some ideas.
[img=http://img264.imageshack.us/img264/9189/1000733.jpg][img=http://img186.imageshack.us/img186/3043/1000731l.jpg]
Modified by s13KACoupe at 12:24 PM 9/26/2009
FMIC install with silvia front troubles
-
s13KACoupe
- Posts: 5
- Joined: Sat Mar 29, 2008 5:46 pm
- Car: 93 240 coupe
-
Hijacker
- Posts: 14373
- Joined: Wed Aug 13, 2003 4:57 am
- Car: '92 240sx Convertible
'94 F-150 - Location: Fredericksburg, VA
FN-QR
I have yet to ever install a big low mounted FMIC like that without cutting into the bumper cover. In fact, most greddy installation instructions will tell you to cut into the bumper cover.
-
s13KACoupe
- Posts: 5
- Joined: Sat Mar 29, 2008 5:46 pm
- Car: 93 240 coupe
-
shift_SRDETuser
- Posts: 398
- Joined: Fri May 23, 2008 7:14 pm
- Car: 1996 Nissan 240SX SE
Re: (s13KACoupe)
have a greddy as well -- cut cut cut away the only way to make it fit.
-
s13KACoupe
- Posts: 5
- Joined: Sat Mar 29, 2008 5:46 pm
- Car: 93 240 coupe
Re: (shift_SRDETuser)
did you basically mount it in the same location or is yours closer to the engine then mine?shift_SRDETuser wrote:have a greddy as well -- cut cut cut away the only way to make it fit.