flywheel and clutch

Post by **homermartinez1** » Mon Feb 05, 2007 10:07 pm

well my ca just came in but it didnt come with a clutch or a flywheel anybody trying to get rid of those? hit me up.

Post by **ca18datsun510** » Tue Feb 06, 2007 2:08 am

go sr aftermarket.

Post by **homermartinez1** » Tue Feb 06, 2007 6:06 am

would i need to do anything different

Post by **bentvalves** » Tue Feb 06, 2007 6:23 am

yea this was just discussed ill try and find the link later. A few people claim a gear reduction starter is needed, and a few claim the stock CA starter mates up with the SR flyheel tits.

If you go SR, you have many options as aftermarket is huge for that motor. You could also try to find a used CA flywheel from the CA part out on Z ilvia.com, and use a KA disk minus one dowel pin.

hope that helped

Post by **burnout 180** » Tue Feb 06, 2007 2:34 pm

Yeah you need a Hitachi gear reduction starter from an S12 CA18ET. It sounds easy and you will never have to worry about the limited selection of ca kits but for some reason not many people take this route. I don't know if its expesive or hard to do but i wouldn't mind making the modification also if i had more information about it.

Post by **ch187** » Tue Feb 06, 2007 5:18 pm

burnout 180 wrote:Yeah you need a Hitachi gear reduction starter from an S12 CA18ET. It sounds easy and you will never have to worry about the limited selection of ca kits but for some reason not many people take this route. I don't know if its expesive or hard to do but i wouldn't mind making the modification also if i had more information about it.

i didnt need one.. i used the stock ca18det starter it came with.

best thing to do get an sr flywheel and clutch because they are easier to find. sr flywheel bolts work if you dont have those either.

Post by **float_6969** » Tue Feb 06, 2007 6:51 pm

I think the starter issue is dependent on the pressure plate you use. The guy that originally tried this said that the reason for the Hitatchi gear reduction starer was so that the pressure plate didn't rub on the nose of the starter.

Post by **homermartinez1** » Wed Feb 07, 2007 6:40 am

so everything will bolt on correctly ?I just wanna make sure before i buy this stuff

Post by **OmarM** » Wed Feb 07, 2007 10:16 am

By end of week I will have a resurfaced stock ca flywheel for sale, make an offer. It has never been used since it was resurfaced.

Omar 321-277-9467

flywheel and clutch

flywheel and clutch

Re: (homermartinez1)

Re: (burnout 180)

Re: (ch187)

Re: (homermartinez1)

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums