Flanging exhaust pipe?

[Dattebayo]

Its not what you think...lol

After careful inspection of the gap between the cat and the headers, I found the solution to my problem. I need a 1' piece of pipe that has a regular bolt-on bracket welded on one end and the other end flanged out one inch long with a loose bolt-on bracket sliding around that end. I'll try to make a bitmap image roughly sketching this out.

Now all i gotta do is figure out how to get the pipe piece flanged and where to buy the bracket to weld to it and the loose bracket to fit around it. Its some frankenstien sh it, but it might just do the job.

[Dattebayo]

Here's the piece i imagined... is it do-able?

[AZhitman]

Piece of freakin' cake.

Got a week or so? Send me EXACT measurements, and i can make it happen.

Somebody gimme a HARD project!

[Mr1der]

perhaps chrome IC piping?

not that I need it, the bird needs other stuff more then a new IC setup right now, well, ok not that much more:D

widening the product line is never a bad idea right?

[Dattebayo]

It would be awesome if the flange could match a more rounded curve, similar to the stupid bulb i have on the end of my headers...cilck my sig for the pics of "the gap". Ill give exact measurements tomorrow hitman. I wish you were easier to get a hold of...

Edit: Do I need to break out the protractor for this?

[[Zero-S]]

Slide rule maybe...

And a cray supercomputer.

Nah dude all you need is a ruler;)

[silkk]

Somebody gimme a HARD project!

i want my exhaust coming out of the trunk

jk

[Dattebayo]

ah, ill check with this later, ive gotta get it up on a lift, so i might as well take care of it here in MD. Ill let you know if they try to rip me off or something, Hitman.

[Thrwnsprkz]

coming out of the trunk... lol

can you make one of those exausts JDM style that stick strait up 3 or 4 feet after exiting the rear of the car... that whould be sweeet