Exhaust rattle and i know the cause i just need help on the solution

[w1ngzer0]

My exhaust is almost touching my rear diff. on my 240sx. If i push the piping i can get it far enough where it won't rattle. But not exactly sure how to push it over perminatly.

CIPracing told me to bend the exhaust hangers. But wouldn't welded steel be a little hard to bend....

[navysnail]

are all the rubber hangers still in place?

[w1ngzer0]

yep they sure are. There are 3 correct?

[EstoMax]

yea i need to bend my hangers a bit too i think.. but its stainless steel so i was wondering the same... how?

put it on a vice or something?

my exhaust rattles as well except its my muffler i think it rattles against the rear bumper support or whatever the lowest part of the fraem is above it

max

[NISTECH]

The exaust mounts should be bolted to the car. try loosing them all including up near the car and try to reposition it. chances are though when you loosen them all it will naturally fall into its original place. thats if none of them are bent.

[w1ngzer0]

bolt to your frame? your talking rubber or what?

I don't have these nismo mounts but i am just giving an example :Phttp://www.splparts.com/Parts/...r.jpg

[NISTECH]

the rubbers hang from bolted on hangers along the path of the exhuast. They bolt to the underbody of the car.

[w1ngzer0]

yah i thought thats what your talking about. Would the design make it at an angle too? or would that have to be the hanger as well?

Talking about how the muffler is facing up, as aposed to straight out

[NISTECH]

I am not sure I follow what your asking but the muffler when properly positioned should be parrallel with the body of the car.

[w1ngzer0]

by chance does anyone the tq specs on the exhaust?