evildky quick question

Post by **nismo 03** » Wed Feb 21, 2007 2:02 pm

does any one make twin banjo's for the side draft webers

Post by **evildky** » Wed Feb 21, 2007 7:54 pm

you mena like this?not sure of the thread's on the webbers but summit or jegs or any spees shop should be able to get them just a matter of finding out what size bolt thread you needhttp://store.summitracing.com/...w=skuthis is the one pictured with a 12x1.5 thread

Post by **nismo 03** » Thu Feb 22, 2007 10:40 am

no what am looking for is more like a banjo with two nipples.

Post by **nismo 03** » Thu Feb 22, 2007 1:49 pm

something like that

o and am also thingking of going with this if not

Post by **evildky** » Thu Feb 22, 2007 6:43 pm

I don't think I've ever seen a banjo "V" like that!? most setups have a single banjo entering each float with feed lines stemming from a common log much like the one you have pictured only made of rubber with generic steel "T" fittings and of course just an "L" at the end of the line

Post by **nismo 03** » Fri Feb 23, 2007 6:29 am

yeah i know that's what my setup came with. But like i said am trying to clean things up around so it doest look sloppy. i found some at an old shop but the lady wants $25 for each of them

evildky quick question

evildky quick question

Re: (evildky)

Re: (nismo 03)

Re: (evildky)

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums