Engine Mount

[Great White Versa]

I had my car in for service today and the guys told me that I need to replace an engine mount. While I don't doubt them (they've been good to me so far) I still would rather not pay them the almost $200 they want to swap it out, especially since autozone has the same part they would use for ~$50. I've read a few how to guides and watched a youtube video where some dude does it on his truck but couldn't find it written out for the Versa. Does anyone know of Versa specific guide/video/etc for doing this?

Thanks for the help

[Ace2cool]

Which mount is it? It could be easy or it could be hard. Usually you just support the engine from the bottom or with a sling, take the old one out, and put the new one in.

A truck is going to be different, as your engine is mounted differently.

[Great White Versa]

I'm not 100% sure. Using the numbers on the service manual (EM-73): ( https://dl.dropbox.com/s/e1g9gfjs6tj1kf ... 0Mount.pdf )

it for sure is not #1 (was recently replaced) so it is either #2 or #4. I'll have to check, but I can't figure out how to get a good look at the rubber around #2

[Racingline]

If it's the lower mount in the bottom right of the service picture then Racingline makes a replacement. Installation is very simple and can be done with hand tools in your driveway