engine codes

[kickenkrazy]

hooked obd2 up pulled 11 codes!!!!!!!!!reset computer still 11 codes car runs good but slower

[yodawill2000]

And the codes were ??

[kickenkrazy]

all the important ones! it wounlnt run without map sensors tps camsensors so something must be wrong with the part that records them (ecm) it runs alright but tps can be upluged to run better----screwy----

[J30inthe sun]

but tps can be upluged to run better----screwy----

From Page EC-136 in the FSM for the 1997 J30 it says:

The Voltage when the accelerator pedal fully released is approximately 0.35 - 0.65V.

I set my TPS at 0.52V & the IACV should be set to FSM specs for idle RPMs with the car fully warm w/ TPS disconnected. FSM manual instructions should be followed to "RESET IDLE POSITION MEMORY" (page EC-74)

[J30inthe sun]

From Page EC-136 in the FSM for the 1997 J30 it says:

The Voltage when the accelerator pedal fully released is approximately 0.35 - 0.65V.

I set my TPS at 0.52V & the IACV should be set to FSM specs for idle RPMs with the car fully warm w/ TPS disconnected. FSM manual instructions should be followed to "RESET IDLE POSITION MEMORY" (page EC-74)

Oh wait the 94 TPS is different.

[kickenkrazy]

install new TPS runs perfect shifts perfect still plus codes cats sensors cut off with cats(not me ,some hillbillys needed money)install new cats without plugs was going to bypass with kit but it says in my factory 1997 J30 book that they are only there to tell if the cats are making a differenct and they have no affect on engine performance ,but they will pull up a code and turn mil on but they shound'nt pull the rest of them up including new tps after bat disconected but screw it, it halls a** new motor with 56k 400.00 ,car almost perfect bought for 400.00 (drop valve) total investment around 1100 bucks with new cats

[J30inthe sun]

new motor with 56k 400.00 ,car almost perfect bought for 400.00 (drop valve) total investment around 1100 bucks with new cats

NICE FIND!