Emamage rb20det wiring help !!!

[93rbcoupe]

Looking for help on my greddy emamage blue to my rb20det. I have everything hooked up except the green and white wire from the blue box . On the rb ecu pin 27 is the maf signal so i cut the wire and hooked the white wire to the maf and green wire to ecu. But my wideband goes crazy at idle like 17 plus killing the car just trying to see if it's wired correct. Thanks any help appreciated !!!

[themadscientist]

That's what the instructions say. Better go through the whole thing and check all your connections.

http://www.greddy.com/upload/file/e-man ... nstall.pdf

If you got it used, you need to make sure that somebody's old configurations are not set. Did you plug it into a computer and run the software to zero everything out or just d!ck with the adjustment pots on the end?

[93rbcoupe]

Got it used but it was set up for a rb20. All I did was check the Jp and rotary switches were correct. I never messed with the knobs on the front panel. Everything is soldered in already changed to a n62 maf I don't know maybe it's the tune cause when it dies it is a pita to get started back.

[Carl H]

you should see what the box has been configured for using the software tool else it may never run right.

[93rbcoupe]

Will do guys just trying to get everything done before I take it to the dyno 450 bucks for two hours around here !