Eliminating Vacuum Lines

[Jok3r synestro]

Ive got a 1990 KA24E, and was wondering if i could get rid of some of the vacuum lines to clear the clutter, can it be done?

[Justin35ll]

Just get longer vacuum lines and run then under the rad support? That's what I would do at least

[formsim]

Ive got a 1990 KA24E, and was wondering if i could get rid of some of the vacuum lines to clear the clutter, can it be done?

This is the howto i followed to remove all but 2 of my vac lines.no check engine

http://www.ka-t.org/forums/viewtopic.php?t=10789

[Jok3r synestro]

Thx, Took a few hours but got it all done, gonna let the gasket maker sit overnight and try to start it. compression was good in all cylinders so its getting closer

[Jok3r synestro]

Forgot to ask, what do i do with the plugs that go into the sensors? (the electrical ones).

[1KleenS13]

Forgot to ask, what do i do with the plugs that go into the sensors? (the electrical ones).

I would plug them back in . Put new wire loom over the wires.

[Jok3r synestro]

i pulled the sensors and used block off plates to cover the holes.
Modified by Jok3r synestro at 6:20 AM 4/26/2009