EGR Tube Block Off Plate ? Where can I get one?

[Chaotic_Warlord]

Ok I have a newer KA and manual trans that I am dropping into my 95 S14, in th eprocess I am putting on my MR Header downpipe and testpipe and have run into a a bit of a problem. I did a search and the EGR tube is apparently worthless so since I had to take it off to put the header on I have concluded to leaving it off since it doesn't line up with the MR header. Here's my question, what do I use to cap or block off the EGR side of it? The header has a bolt in place that has been tightened down so that there isn't a leak from the exhaust side. Also where is the EGR sensor so i can wire in a resistor to cancel out the CEL light, and what size resistor do I need. There were only a handful of threads about this and they all said about the same thing, throw the EGR tube away and block off the EGR valve but none state what to use to block it off.

[180fan]

If I'm not mistaken, you should be able to order one from the dealer. search for the part number, I've seen that part number come up a couple times in different threads.

[bige240]

If you can't get one from the dealer (they do sell them), you can get one on ebay