ECU Q

[Frankenstien93]

If i want to do a 5spd swap do i have to have a ECU for a manual? another Q is i was looking to get my ECU flashed and programmed my goal is 350-400 hp i am completely rebiulding the engine i just want to know what i will need to get there and where would i send my ECU too to get the programming and aprox. cost?

[PapaSmurf2k3]

I beleive if you keep the same ECU (auto) you will not have any speed limiters. And your going to want to send the ECU to either JWT, or enthalpy to get a tune. search button is your friend for prices

[Frankenstien93]

thx for the info i think im going to go with enth. my last q is what setup would work if i have a t3/t4 turbo would i be able to even reach a 350-400 hp goal?

[drb930]

Have you looked into the BIKIROM

Here is the thread.

zerothread?id=183508

[KATwo40]

You can also get it tuned by deviousKA on this forum, but he's VERY busy lately, as he just purchased.....

/gasp......

A Dyno!!!! Wooohoo!

Anyhow, that is all.

[Frankenstien93]

i would do i but i honestly dont know that much about the electronic side of cars and for something as important as the ECU i would much rather just have a pro do it and i heard Enth does really good work. but i have to purchace new injectors due to mine melting in a bad firewith pretty much everything else...lol so i was looking to see what injectors i should get and im guessing that i would need to get a Z32 maf but would i need to get a whole new fuel system too? ive already upgraded my fuel pump to a walbro 255. and i already know that i have to get forged internals. but is there anything else im forgetting to get to my goal?

[wild_maxx]

You can also get it tuned by deviousKA on this forum, but he's VERY busy lately, as he just purchased.....

/gasp......

A Dyno!!!! Wooohoo!

Anyhow, that is all.

HAHA yes he did and i only live 30 minutes away from him!

Once he gets it all set up we are going to fine tune my ECU. He's one smart dude.