ECU has no power after swap

[240dx]

I just swapped in a kouki s14 SR20det into my 1997 240sx, The motor will turn over but has no spark or fuel.
I found the ecu has no power, all grounds have been tested and are well. Where does the ECU source power from the battery and ignition? Is there anything I should check first?

[240dx]

Its most likely something very simpl but i just cant figure it out. Why does my ECU not get power??

[Hoffman5982]

click my build thread in my sig. I have a diagram of how I wired my dash harness up. I tried 2 other diagrams before making my own, and I didn't get power to the ecu with either of them. I wired it myself, and it got power fine.Im having the same problem, except mine ran for a while, and since then it just turns over. My ecu gets power and everything, I just don't know whats causing it not to start.

[mikecef2]

Make sure you crack the case of the ecu on a clean table of course and check out the pin outs on the inside to the circuit board. It sounds like a similar problem I had and I found that the main ignition power line, fuel pump line, and ignitor line were fried on the circuit board.