ecu code question

[Nismo240gts]

this is kindof a rookie question but if I have a 91 s13 and a 98 r33 rb26 how do i pull the codes off the ecu? I know this is probably a question someone has already asked but i searched and could not find it.

[Carl H]

just like you would with any other nissan, use the dial on the ecu...

[Joe]

or if you want to be baller, get a consult cable and program

[Nismo240gts]

Sorry but what dial on the ecu. I dont see one. Here are a couple pics of my ecu and where i thought the dial would be. sorry for bad pics but they are from my cell phone.

[Joe]

it honestly wouldnt surprise me if they did away with it. its kind of an archaic system in comparison to the consult program

"ok count the blinking lights!"

[Nismo240gts]

yeah there is definately no led or light of any kind on my ecu anywhere.

[Kansei240sx]

I have the same problem on my RB25DET. i HAVE the dial, but no LED's in the ECU to speak of. I was told that i could wire up my check engine light on the cluster to get it to blink at me, but im not sure which pin to use.

[Carl H]

wow, ok that sucks.consult cable time, i know i wired it in on your harness.

[Nismo240gts]

yeah I think I am gonna get a consult cable. I also think i found another way to check the codes in the fsm. I am not near my car right now so i cannot test it but when I do if it works I will post it up here for anyone who has the same issue.

[eh?]

R33 FSM pages EN-296-297.

ahhhh beat me to it.

[Kansei240sx]

I hate to threadjack, but does anyone know where i can find the R33 ecu Numbers?

EI His ecu is 24U01 , i think i have a non skyline ECU. Here is a side image, this is how it was when i got, except the sticker you see what perfectly stuck onto the surface, i just peeled it back.

Inside that hole where the LED should be, there is nothing, just like the original poster of this thread. Also, that sticker covers over the holes for the dial and hole for the LED, but its never been probed before, untill me.

[Carl H]

if you have a non led ecu then it uses the cel to flash codes.the old led ecu also will flash the cel when throwing codes...good to know.

[Nismo240gts]

yeah the cel is what I am going to try when I get back to my house. just like it says in the fsm.