cranked the SR last night for the 1st time

For the RWD SR20DET cars! Sponsored by Wiring Specialties.
User avatar
mmashburn
Posts: 126
Joined: Thu Mar 31, 2005 2:01 pm
Car: 1992 240sx

Post

I cranked up the SR20 for the first time last night, but havent taken it for a drive yet... it idles beautifully at 700 i think.... im impressed with how loud it is with only the greddy turbo elbow and the greddy downpipe.

heres a few minor questions for you guys...

1) theres a plug coming off the power steering lines... where does it go?

2) theres a plug near the battery tray, kinda below the fuse box hanging down that i didnt use either, i dont know what it would go to... everything on the main and lower harness is hooked up.

3) is it normal for the clutch to feel dead, its just all the way to the floor, but it's topped off with clutch fluid.. do you think bleeding the lines will take care of this?


VectorVA
Posts: 17
Joined: Sun Aug 01, 2004 1:16 pm
Car: Drifting

Post

1) The plug connected to your power steering lines is a sensor that should be hooked up. Just look for the same plug on your main engine harness and then extend the wires across the front of your engine bay.

2) The plug under your battery tray might be for your AC cooling fan that was on the KA radiator. Unless your using AC, dont worry about.

3) Bleeding the lines couldn't hurt.

User avatar
9240sx
Posts: 2676
Joined: Wed Dec 10, 2003 4:06 am
Car: What i believe to be the cleanest s13 in the world.

SR20DET + RS*R-Apexi-Nismo-Trust-HKS= 100% pure love
Location: New Mexico

Post

You dont need to have the harness off the PS line hooked up.Iv never had mine hooked up since I got done with my swap.And that was years ago.


Return to “SR20DET Forum (rear-drive)”