Crank Angle Sensor

[davidp94]

I was having an issue where my 300 wouldnt start and it was a fault crank angle sensor connector. After a wiggle, it would fire. To prevent any accidental release of the connector while im on the road (because its happened) i bought a new one from conceptzperformance.com. At this point all i need to do is splice and crimp the wires together. However the colours coming out of the existing connector and the new one dont match up. What should i do?

Additional information:
The wires on the existing connector are from top to bottom:
- black, black/white, green/black, green/yellow

The wires on the new connector are from top to bottom:
- black, green, white, and red