Corrected Dyno Charts for Boost Design Kits Stage 1 & 2

[xatracing]

BTW.. this is the same kit on 8 psi.. sae corrected / smothing 3 .. just because i caught some flak for that .. and the same 12 psi run as up top .. but sae corrected... btw that is 288 foot-lbs torque at 3700 rpm... no clutch slip down there.. just the e01 being squirrely with the set boost.. KA's are cool

martinXAT Racing813-875-7223http://www.xatracing.com

[DammitBobby]

Can`t wait to get the stage II installed!!

[BomexS13]

nice..

I emailed boost designs but didn't get any reply...that was like a couple months ago.

[GEO]

iii aammm loooviiiinn it

[sunnys14]

im glad i bought stage 2!!!

[pimplayahustla]

are you using e-manage with your stageII or a different computer?

[xatracing]

e-manage and e-01 comes with a stage 2 i think... i tuned this setup with that... to do a good job you need the following1. dyno w/ wideband2. the ignition map of a ka ecu to make ignition tuning easier and more precise..3.. TIME... it takes a while...

MartinXAT Racing

[pimplayahustla]

I actually got the stage one but I purchased 550 cc blitz side feed injectors and the Enthalpy tuned ECU, which Scott tells me will be at 15psi tuned for the 550cc injectors. I was told to expect at 300 whp myself.

My next question would be - could you use a manual boost controller and S-AFC to fine tune or are you not going to get enough feedback?