Compression tester adapter stuck in spark plug hole!!!!

[import93_123]

I was doing a compression test and when I went to unscrew the compression tester tube from the spark plug hole it left the adapter in the hole I tried takeing a 11/16 socket to get it out but it wouldn't fit in the cylinder wall. I am going to try to get a thin wall socket but I am not sure if that will make a difference. BTW, My car is a 95' 240sx. Thanx

P.S. I'm only fifteen and this is my first car so don't give me any s**t about anything.

[float_6969]

Put a little loc-tight on the tester and thread it back into the adapter. Let it sit for a couple of hours and then try unthreading it.

[P_856]

same thing happen to me i didnt screw the end down tight enough i just found a long screwdriver and rolled alot of tape on the end sticky side on the outside of course and shoved it down the hole and screwed it out it the tape was sticky enough to lift it out too 3m super 33+ FTW

[import93_123]

Thanks so much , I just got it out this morning befor I went to church

[float_6969]

Glad to help!