Cnc brake install gone wrong!! Need some help

[godrifttoday]

ok im pretty good at following directions, and woking with cars but im stuck here. i posted the pic of how my lines are set up. i bleed the brakes but i only get fluid being sent to the front of the car... i get no fluid sent to the back of the car none! with and with out activating the hydro e brake. i do get fluid to the back of the port on the cnc while pressing the brakes but no fluid comes out from the side port that is going to the rear brake.. so im stuck here any ideas? and solutions?

car s13, no motor yet, z32 right hand drive brake master cylinder ( use for turbo line clearence)

[Roger_cha]

well you said you have no motor yet on the car. you have to turn on the engine to get vacuum for the brake booster in order to bleed the brakes.

[godrifttoday]

Not necessary... U can do both wayS but I get fluid into the rear port of the cylinder but it does not come out onn the side

[Roger_cha]

you might have a clog in the hydro ebrake then. if not then try lifting up the handle up and down like you are bleeding it see if that helps.

[godrifttoday]

I tried that lke I said I do get fluid yo the cnc cylinder but it does not transfer to te back?

[Roger_cha]

is your hydro ebrake used or new. try checking to see if there is anything clog in it. o and try to pulling the ebrake up and down and see if the fluid pushing back to the master cylinder if it does then you got it backwards.
Modified by Roger_cha at 1:34 AM 12/18/2009

[godrifttoday]

hydro is new here are some pics of the setup

[Roger_cha]

well you setup is different then my buddies setup. im not sure how the cylinder in the ebrake system is set up. try to swap the lines around and pump it to see were the fluid is coming out of. as for the master cylinder it seems fine cause i got my set up the same way, but with a usdm 300z brake master cylinder, but with no hydro ebrake.
Modified by Roger_cha at 4:09 AM 12/20/2009

[godrifttoday]

Ok guys I figured it out... The diagram I have is the correct way to install it. THe problem I had was the fitting that goes into the cnc piece... Not the brake line but the little gold fitting... For one it was damage and 2nd it was on to tight... There is a little hole in the back port and when tighten to tight tHe gold fitting covered it... So once again it is the correct way to install the hydro e brake

[Roger_cha]

well good to here that you figure it out. looks like you are going to be needing to replace that fitting, just dont screw too tight next time, give us an updates how things are going.