Clutch slave bolts

[Seishuku]

Can anyone tell me what the bolt dimentions for the clutch slave cylinder are?

I can't tell if the mount point on my bellhousing are striped or if I just don't have the correct bolt size.

The bolts on my old setup were M10x1.50, but I can just slide those into the holes.

Is it an M11x1.25 or M11x1.50? I tried searching here and google, but no luck.

[xero1]

i think the clutch slave cylinder boalts are 8x1.5 mm or 8x1.25 with a 12 mm or 14 head? but japanese cars don't use 11 mm boalts, jap cars only use 5,6,8,10,12,14 or higher boalts.

[VitaminT]

I can't remember what size the bolts for the slave are but I know the 4 transmission crossmember bolts are M10x1.5. Maybe you can compare them and see if they are the same. I am pretty sure if the head is a 14mm socket then they will be a M10.

I would go out and run a tap in but it is like 20deg outside.

[Seishuku]

Yea, they are M10x1.50 and my bolt holes are stripped apparently, or are dilled and tapped to a larger size that I can't find a bolt for. It's not 3/8, it's not 7/16, it's not M10, it's not M12... No one sells a M11 bolt, so I can't check that.

I think I'll just retap it for a larger bolt, maybe M12 or a 7/16 and just go with that.