Clutch replacement

[TrukillaS14]

Ok so my friend and I decided to replace my clutch in my s14, the previous owner had a kevlar-metal clutch and a fidanza flywheel ( not to sure which type of fidanza it was). So we got to take everything off and the clutch its basically worn so i kno we're replacing it and the pressure plate is STRAIGHT up gone, but the question is what the hell do I do with the flywheel. I kno I'm so suppose to machine it down but I don't know if I should cuz its pretty worn but I don't kno how worn it is. I mean i dnt if its still good or not. I'll have pictures up later since its not letting my load any.

[OutToWinPAHC]

If its an aluminum flywheel just replace the friction disk. That's why they are bolted on, they run about 50-70 bucks. Torque each bolt to 60in lb

[TrukillaS14]

I found that out but do u kno how to replace it and take off the friction disc cuz when I tried I almost stripped it. I looked every where online to find instructions to replace the friction disc but no avail.

[Dattebayo]

I assume what you mean is that the friction disc is worn well into the mounting hardware?

Take the thing to a machine shop and have them remove it then.

[OutToWinPAHC]

The new disk comes with new hardware. 10mm socket and a screw driver. Drill out the ones that are stripped.