Clutch problems on 91' 240sx ka24 5speed manual trans

[jalvarado]

OK, it started when my clutch petal dropped to the floor, I had the slave cylinder replaced work ok until day 3 or so shifting became HARD, next clutch was replaced same thing on day 3 or so same problem, took it back and they bled it and assured me it was ok, nope replace Master cylinder work ok for 5 days. same problem which is durning my drive home it becomes difficult to shift and i can hear something spining. so PLEASE HELP!!!!!!!!!!!!!!

[modulation]

Did you remove the clutch dampener?http://www.zeroyon.com/index/content/view/32/47/

If not remove it and bleed again.

Also did you get a new throw-out bearing when your clutch was done?

[jalvarado]

There is not dampener, the entire system was replaced with oem parts including the flywheel. STILL problem starts on my drive home 5 miles into it. I Clutch engages but it is difficult to shift. I have replaced the clutch 2X and flywheel once, OEM parts same problem. starts ok in the morning (10 miles) on the way home it acts up. shifting is hard and it does not respond as fast when accelerating. Also both cylanders where replaced.

Thanks

[sirgilbert357]

Well, I say bleed your clutch and then bleed it again. Just do the regular pedal pumping process with a friend and once you're done, do it again. If you still have problems, is it only after the car is warmed up? And you didn't really answer if the throw out bearing was replaced for sure. Was it?