Clutch Pressure issues :(

[sonny1335]

I have a 93 with a Rb20 swap. Recently my transmission went out so i put a new one on, i didn't mess with the clutch or pressure plate. I put a KA slave cylinder on and when i tried to go bleeding the slave cylinder i still don't have clutch peddle pressure. I tried removing the dampener so the line goes straight to the slave cylinder but still nothing. I'm stumped and i really wan a drive my baby i have and extra master clutch cylinder that I'm going to put it hopefully that does it but i ran out of ideas. Help please!

[compactfean]

Id say master is bad or you're not bleeding properly. You can't bleed the clutch like you can the brake pedal. Id just gravity bleed it and then tighten and see if you get all the air out.

[Fastazz240]

i had this issue on my s14, if it is totally dry pop the hardline off the master to get it to come out of there. There is a way to do it via two people and pumping. im not sure of the specifics been a while since i swapped my vert. I will get back to you on that one. And are you sure the Ka slave works like it should?

[OutToWinPAHC]

i had this issue on my s14, if it is totally dry pop the hardline off the master to get it to come out of there. There is a way to do it via two people and pumping. im not sure of the specifics been a while since i swapped my vert. I will get back to you on that one. And are you sure the Ka slave works like it should?

http://youtu.be/m6iwrhZCdwc

[sonny1335]

thanks guy for the input, i was stumped and i got it to work. i was not bleeding it right , so i went to sears and got one of those bleeding pumps and bam!

[Fastazz240]

congrats on the fix