clutch option

[F3600]

Hey everyone, i removed my clutch assembly today to find that my clutch is bad so i need to know wich clutch i can use on my ca18det.

I have a KA24E clutch right now, almost new, i think i can use it but the pressure plate wont bolt can i use the CA pressure plate?

thx

[Nismo1182]

The KA clutches work, you have to drill out one of the alignment pins on the flywheel. SPEC makes CA18DET clutches also.

[F3600]

i drill a hole in the flywheel or in the pressure plate ? just to be sure.. cause i tried to test fit the KA pressure plate there was 2 alignment pin that was okay with the pressure plate.. it seemed that i just need to drill a hole in the pressure plate for the third alignment pin and Voila .. ?

[Nismo1182]

Well, you can drill a hole in the pressure plate. But most people cut the pin on the flywheel off with a dremel tool or something similar. Then the pressure plate bolts right on. Its a lot easier and faster.

[NeedCAforS13]

the pin just pops out if you use vice grips on it and pull... thats what I used (stock KA pressure plate with aftermarket disk;))

Sean

[nab911]

well damn, i wish i had known this when i bought my clutch