clutch install...need help

[cb_240]

have an os giken twin plate clutch and was going to install it but cannot find the torque specs for the flywheel, the pressure plate and whatever else has to be torqued down. i looked in the r33 fsm for the factory specs but no luck. please help

[rustbucket]

Flywheel 142-152Nm (105-112 ft-lb)Pressure Plate 34-44Nm (25-33 ft-lb)

[cb_240]

thank you very much

[NizzansDET]

Can you replace the clutch with the engine in the car? my friend said a rb 240 you cant get to the transmission bolts so you have to pull the engine? I havent had time to figure it out but do you know?

[rustbucket]

Yes you can replace the clutch with the engine in the car. Take the transmission mount down, pull down on the tail end of the xmission and use a long 3-4 ft extension with a universal jointed atachment to the socket. This should allow you to get the top bolts out.

[IronMonkey]

it is a very much pain in the *** to do a clutch job with the engine still in the car. I had no problem taking off the transmission, but putting it on was a real pain. so i highly recommend taking engine/transmission combo off. i did that to my other rb and it was way less time consuming.

[NizzansDET]

i lifted the engine up and moved it forword about 3 inches. then took off the trany. that was easy