Checking Injectors (ohm test)

[-=BoYo=-]

How exactly do you check the injectors step by step, with an ohm meter?

which harness do yo check? is it called E.C.C.S and were is it...

[-=BoYo=-]

opps I have a 93' Z32 TT

[evildky]

pull the harness connectors off of the injectors and measure impeadance across the connectors with a multimeter set to ohms, I don't knewo the specific value for Z32 injectors but look for any of them that test higher or lower than the rest, and a reading of zero is a completely dead injector

[-=BoYo=-]

no.4 and no.6 were shot 4 was 24ohms and 6 was 93ohms....im gonna dig in now and check the connection at the injector..

[Q45tech]

An ohmmeter measures resistance not impedence [which is expressed in Henries, millihenries, etc] from an impedence bridge.

Always measure injectors twice [cold and hot] to get to possible problems.