Post by
brentbell »
https://forums.nicoclub.com/brentbell-u174773.html
Tue Dec 21, 2010 11:04 pm
Ok- I have a 1990 300zx 2+2 N/A. My current mods are- Stillen pop charger, headers,cat delete/down pipes, cat back exhaust, lightweight underdrive pulley.- I just joined the forum and happen to see this subject, which is my problem.
I recently purchased an Eprom Chip from E-mance tuning...did not know it was just the Eprom and there was other things I would possibly have to purchase, or would need besides the actual chip. Today I went to a couple places and took out the computer & showed these companies my computer asking for help with the chip install. My question is- Has anyone ran into this problem before? what do I need to install this Eprom on my computer? just want to be sure I don't F@#$ up my car getting to excited about this damn chip and get someone to solder the new chip into my computer. Also the board above the main board( sits about an inch above the main board and has 4 screws) has freekin apoxy all over it and I can't get the damn screws out. any suggestions on solvents? other ways around this?
Thanks!