Car starts and drives up 2000-3000 rpm then stutters and dies-vaccum line?

Post by **leesredgt** » Sat Nov 17, 2007 8:55 am

i verified that the MAF was good and i verified the voltage at the connector and as far as the temp sensor which one did i need i mean my gauge is not working either so which two do i need to get i still have my old ka but ive heard those sensors dont read right?

Post by **eh?** » Sat Nov 17, 2007 7:08 pm

The single wire sensor is for the dash gauge, use the KA sensor for that. The RB25 ecu uses a two wire sensor, that is the one you should be worried about.

Post by **leesredgt** » Sat Nov 17, 2007 7:23 pm

also to someone told me that it could be a bad ground wire in the maf plug does a wire(ground) need to go in this spot?

Car starts and drives up 2000-3000 rpm then stutters and dies-vaccum line?

Re: (eh?)

Re: (eh?)

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums