Can I toss a KA24DE into an 89 ??

Post by **Speed-Techniques** » Sat Aug 02, 2003 4:25 pm

If so what's required, besides the ecu.

Luke

Post by **red240ne** » Sat Aug 02, 2003 4:25 pm

yes. question has been asked many times over and over.

ECU, wiring harness, engine/transmission.

Post by **IveBeenBad** » Sat Aug 02, 2003 4:25 pm

tach is needed too

Post by **revhard05** » Sat Aug 02, 2003 4:25 pm

transmission ist nessary......its the same block ..

Post by **Speed-Techniques** » Sat Aug 02, 2003 4:25 pm

Thanks for the replies, I can't use the Ka24e gauge cluster then ?

Luke

Post by **MainEvent212** » Sat Aug 02, 2003 4:25 pm

it's just like doing an SR20 swap...

Post by **PGZX3** » Sat Aug 02, 2003 4:25 pm

I think you have to swap the cluster with the ECU and harness....kind of like the RB swaps....

Post by **prigo** » Sat Aug 02, 2003 4:25 pm

I got a KA24DE if you're needin one ^_^

Post by **Speed-Techniques** » Sat Aug 02, 2003 4:25 pm

where are you located prigo ?

Post by **KSee777** » Sat Aug 02, 2003 4:25 pm

so is the power steering lines needed as well?

Post by **red240ne** » Sat Aug 02, 2003 4:25 pm

revhard05 wrote:transmission ist nessary......its the same block ..

wrong.

Quote »Originallly posted by KSee777 "]so is the power steering lines needed as well?[/quote]yes.

Post by **revhard05** » Sat Aug 02, 2003 4:25 pm

ecu is the same too ....dude i have did this swap before all i needed was the engine and harness no transmission i used my old transmission:D