Just trying to get confirmation that the ca18 specific strut bar will clear a rb25 with stock intake manifold. I'll be using the ruckus-racing mounts with less than 1k miles on some nismo mounts.
I mean, I know it could vary, but just in general. They're also hard as hell to find. I can only find the cusco model via frsport.com
ca18det strut bar
Re: (Carl H)
Ah, ok. I didn't know that's where the interference was. Thanks.Carl H wrote:chances are no, mainly due to the jpipe causing most of the interference with strut tower bars.
-
l0nestar
- Posts: 2251
- Joined: Fri Mar 10, 2006 5:24 am
- Car: 1993 Nissan 250SX
2004 Toyota Altezza
1963 Chevy Impala SS - Contact:
Re: (StricNyne)
I believe it is spelled 'Cusco'. Jason (RotorPimp) also makes an S13 front strut bar that is by far stronger than anything else you can buy, that is JDM.StricNyne wrote:custoco makes a triangular strutbar that will work, also in fab market someone makes one that will work also
Although, a lot of people have been requesting them, but no response back from RotorPimp I know he is a pretty busy guy though!
Re: (StricNyne)
"custoco" lol Yeah, I'll have to track one down.StricNyne wrote:custoco makes a triangular strutbar that will work, also in fab market someone makes one that will work also
Yeah, I found that thread after some searching a while back. I think I posted in it myself.l0nestar wrote:
I believe it is spelled 'Cusco'. Jason (RotorPimp) also makes an S13 front strut bar that is by far stronger than anything else you can buy, that is JDM.
Although, a lot of people have been requesting them, but no response back from RotorPimp I know he is a pretty busy guy though!
Bah...I know you have to pay to play, so to speak, but a strut bar is something that I would hope didn't fit into that category...now Im wondering if I even need one. I have F+R sways and a rear strut bar.