CA18de Harness on a Ca18det

Discuss topics related to the CA18DE and CA18DET series engines.
Post Reply
User avatar
oversteer180
Posts: 933
Joined: Tue Mar 15, 2005 2:28 pm
Car: 1990 Silver 240sx

Post

ok well, i have access to an ca18de pulsar fwd harness. I was wondering if there was anyway i could use this harness on my motor? or what i would need to add to it from my ca18det harness to make it work. Also did these motors come with dropping resistors that will work on ca18det's?

Top
dattodude
Posts: 430
Joined: Wed Jun 29, 2005 2:51 am
Car: CA18DET Datsun 1200 B110 Sedan
Contact:
Contact dattodude

Post

No dropping resistor for injectors, easy enough to wire in. Many engines have the dropping resistor. Better to get one from a CA18det. But any 4 or 8 cylinder engine with injection may have them.

Need extra 12V for the o2 sensor heater.Need some wires for the boost control solenoid.

Loom might be shorter, If it's going into an S13, then that's not so good.

Top
User avatar
biosehnsucht
Posts: 1839
Joined: Thu Feb 26, 2004 10:20 pm
Contact:
Contact biosehnsucht

Post

ECU connector is totally different from what I understand, so totally useless.

You can use DSM injector resistors from 1st gen eclipses etc, different connector but thats just a wiring issue.
Top
Post Reply

Return to “CA18DE / CA18DET Forum”

Search for Nissan stuff on ebay!
Find Your Forum!

 

NICOclub's Nissan forums and Infiniti forums and all affiliated sites are the property of HDS Holdings, Inc.
They are independent publications and are not affiliated with or endorsed by Nissan or Infiniti.

Information Copyright © 2000-2026 by NICOclub, all rights reserved. Material may not be copied or reprinted without written permission.

Privacy Policy