bottom end setups...

[FusionR300zx]

what bottom end setups are you guys running? non stock of course...

trying to find a good setup.

please provide what bore and everything u got

i'm deciding on what to get.

[FusionR300zx]

is everyone runnin a stock bottom end er whut?

[DrifterProdigy85]

I am and im putting out near 400whp. Ill be rebuilding a block this winter with CP Pistons and Eagle Rods.

[vutony]

depends on wat your plans are for the car

check out FA for more info

[ZL-Auto]

CP 9:1, Eagle Rods, ACL race bearings.

[karmakaze]

its not assembled yet, but the only thing i need to get now are bearings and the machine work done.

cryo treated crank/blockarp main studseagle rods w/arp studsCP 90mm 9:1cr pistons

[redtop91]

LOL I'll be doing the same as everyone else. 9:1 CP pistons Eagle rods, new crank and bearings. It should be noted that I'm not rebuilding because the SR can't handle my power expectations (400whp) rather is that it probably cannot handle my expected redline of 9200.

[luv2spedup]

86.5 mm stock compresion cp pistons brain crower rods etc, now wating to see the results (cause im in the process of puting the motor in now)

[FusionR300zx]

has anyone just ran CP 86.5mm piston with stock rods?

prolly gona get crower rods, arp rod bolts, cams, valve springs, ratainers

idk what seals to get.