BOTH P1145 and P1140

[Wester97]

I have both codes P1145 and P1140 right now. What does this mean? Is it both sensors or is it most likely a solenoid problem? I didnt try the swap trick because they are both throwing codes.

Thanks in advance!

[Wester97]

Do you think I should try swapping the sensors anyway?

What should my next step be?

[timmack]

seems like most ppl that run into the p1140 and p1145 end up changing the sensor(s), not the solenoid. id buy one sensor, slap it in and reset the codes and wait for the cel to come back on, then read the code and see where youre at. if you only get one code, then you know you gotta get another sensor and swap the other one.

[Wester97]

I will try another sensor.Is Pinnacle my best bet?Mechanical Catalog > Electrical > Powertrain control > Camshaft position sensorFront: $57.20Rear: $93.67

(I thought they were the same part)
Modified by Wester97 at 7:59 PM 10/30/2007

[timmack]

that i couldnt tell you. i didnt know there was a rear? thought it was just banks 1 and 2, in the front. i took this pic to the dealer, circled the part i needed (23731tb) and told him what code i had and he knew exactly what the part was. yea i paid 84 bucks for the part but i wanted to make sure i was getting the right one, didnt wanna fumble with returning something that showed up in the mail and wasnt correct.

zer...c.JPG

[Wester97]

I am buying 2 sensors online. If I only need one, can I sell the other here on the forums?

[timmack]

yep nico has a classified section...

zeromain?id=174

[j0321]

I have the same problem with my 01 pathy. Did you finally get yours fixed? If so, how?