Boost controller makes car STALL.

For the RWD SR20DET cars! Sponsored by Wiring Specialties.
User avatar
maku_gx
Posts: 149
Joined: Tue Sep 05, 2006 3:37 pm
Car: 240sx

Post

HelloI just got my car working from MA motorsports but It just stalls when revs go low.I believe its from the boost controller or the connection\install of cables wasn't made correctly.either way, I'm not sure. these were buddies opinions and I'm trying to find out what it is.

If anyone has a clue what the problem could be, please tell.

car is 180sx, 91.Its been sleeping for over 6 months before i bought it, then i used it a bit until the radiator and a few things blew up.i sent it to MA and its been there for a month and a half.when I got back It was still not working well, so I'm trying to work it out to make it work good.

thanks!


User avatar
SpeedRacer1
Posts: 3144
Joined: Fri Jul 26, 2002 7:44 pm
Car: 1990 240SX, G35

Post

Is there an atmospheric BOV on the car? This will cause stalling. Vac leaks? Proper timing? ECU error codes?

User avatar
grmreapr
Posts: 692
Joined: Thu May 10, 2007 6:00 am
Car: 89 rps13, 02 mazda protege
Location: NJ/PA

Post

sounds like an atmospheric bov I had the same problem till i recirculated it cleared right up now i still bog cause of fuel issues but check you bov


Return to “SR20DET Forum (rear-drive)”